What to Do When Your Phone Gets Wet, Step by Step
A friend dropped her phone into a kitchen sink last March, fished it out in about two seconds, dried it on a tea towel and plugged it in to check it still worked. It did, for eleven hours.

A friend dropped her phone into a kitchen sink last March, fished it out in about two seconds, dried it on a tea towel and plugged it in to check it still worked. It did, for eleven hours. The next morning the screen had a grey cloud in one corner and the charging port had stopped responding. The water did not kill that phone. Putting a charger into a wet port did.
Water damage is one of the few phone problems where the first ten minutes decide the outcome, and where most of the popular advice makes things worse. Modern phones are not sealed boxes. They are assembled with adhesive gaskets that resist water under specific lab conditions, and once liquid is inside, what matters is whether electricity is flowing and how quickly the water leaves.
What the waterproof rating on the box actually promises
IP68 is the number most flagship phones carry, and people read it as waterproof. The test behind it is narrower than that. For most phones it means 1.5 metres of still fresh water for 30 minutes, in a lab, on a new unit, at room temperature. Some manufacturers test deeper, and a few state 6 metres, but the principle is identical: static clean water, briefly.
Three things fall outside that. Pressure is the first, because moving water pushes harder than still water, so a shower jet, a wave or a swimming stroke can force liquid past a gasket that would hold at depth. Temperature is the second, since hot water and steam make the adhesive softer and the air inside the phone expand and then contract, which draws liquid in as it cools. Age is the third and the one nobody thinks about. Those gaskets are glue and rubber, they harden over two or three years, and a drop that cracked the back glass has usually broken the seal even if the phone looks fine.
Fresh water is also the kindest liquid your phone will meet. Salt water is conductive and corrodes contacts within hours. Chlorinated pool water leaves mineral deposits as it dries. Coffee, beer and soft drinks leave sugar, which pulls moisture out of the air for months afterwards and keeps a circuit damp long after the spill looks dry.
The first ten minutes, in order
Do these in sequence and resist the urge to test anything.
- Get it out and hold it port down. Gravity is the most useful tool you have in the first minute. Keep the charging port and speaker grilles pointing at the floor.
- Do not press the power button, and do not plug anything in. If the phone is on, leave it on. If it is off, leave it off. Current through a wet board is what causes permanent shorts, and that is also why the charger is the single worst thing you can reach for.
- Wipe the outside with a dry microfibre cloth. Pay attention to the seam around the screen, the SIM tray edge and the camera ring, because water sitting there wicks inward.
- Pull the SIM tray out. That gives you a second drainage hole and lets you check the little white sticker inside, which turns pink or red once it has been wet. Technicians look at it, so you may as well look first.
- Tap it gently against your palm, port down, eight or ten times. This is what the manufacturers suggest and it genuinely clears the port and speaker. Do not shake it hard, since that distributes water further into the chassis.
- Leave it somewhere with moving air at normal room temperature for at least five hours. A desk with a small fan pointing at the port is ideal. Prop it upright against a book, port down.
- If you need to charge, use a wireless charger. No pins, no contacts, no current across a wet connector. On a phone with a liquid detection alert, wait for the warning to stop appearing before you use a cable, which can take a day.
Twenty four hours of patience is the target with anything other than a brief splash. The impulse to confirm the phone still works is what ruins phones, and I have yet to meet anyone who regretted waiting.
Why rice is the worst popular advice in consumer tech
Uncooked rice absorbs moisture slowly and only from air it is in contact with. Inside a bag, it dries the air near the surface of the phone, not the air inside the chassis, and the phone's own enclosure is what slows evaporation. Tests comparing drying methods have repeatedly put rice at the bottom, below simply sitting in open air, and Apple now says in plain terms not to use it.
The active harm is mechanical. Rice sheds starch dust and broken grains, both of which fit into a charging port and a speaker grille perfectly. I have cleaned rice grains out of two USB-C ports, and in one case the grain had swollen enough to bend a pin. A phone that was going to survive now needs a port replacement.
The other three bad ideas are quick to dismiss. A hairdryer pushes warm air at the phone, which drives liquid deeper and can lift the display adhesive at anything above gentle warmth. A freezer turns water into ice that expands against components. Isopropyl alcohol works in a repair shop because the technician has the board out and can submerge it, which is not a thing you can do through a charging port.
If you want something better than air, silica gel is it. A sealed container with four or five of the sachets that come in shoe boxes and vitamin bottles will pull humidity down meaningfully, and it leaves no dust. It is still slower than a fan over 24 hours in a dry room, and it is not worth buying specially.
Signs that you should stop and pay someone
Some symptoms mean water has reached the board and drying it yourself will not reverse what is happening. Corrosion starts within a few hours on salt water and keeps going after the phone looks dry.
Take it to a repair shop the same day if you see the screen developing patches that spread, hear the speaker crackle or sound muffled after a day of drying, notice the phone running hot while idle, or get a battery or charging error that persists. The same goes for any phone that went into the sea, a toilet, a pool or a sugary drink, regardless of how well it seems to be behaving.
Expect the conversation to be about cost rather than repair. An ultrasonic board clean runs roughly 60 to 120 dollars at an independent shop and is often done the same day. A screen or port replacement on top pushes the total to 200 to 450 dollars depending on the model, and manufacturer warranties generally exclude liquid damage, which is what that little sticker is for. If your phone is three or four years old, the sensible answer is sometimes to stop spending. Our note on whether an extended warranty earns its price covers which policies actually include accidental liquid cover.
One thing worth doing this week, while nothing is wrong: check that your photos and messages are syncing somewhere other than the phone. The part of water damage that people actually grieve is the pictures, and a working backup turns a 400 dollar disaster into a 400 dollar inconvenience. Our guide on backing up photos and files walks through the free options. If the port is the part that stopped working, the steps in a phone that will not charge are worth reading before you book a repair.
FAQ
How long should I wait before charging a wet phone?
At least five hours with a fan, and a full 24 hours if anything other than clean water got in. If your phone shows a liquid detected warning when you connect a cable, the phone is telling you the port is still wet, and the warning exists precisely because charging then causes corrosion.
Can I use my IP68 phone in the shower?
You can and many people do, but you are outside what the rating covers. Shower water arrives with pressure and heat, and soap reduces the surface tension of water, which helps it slip past gaskets. The risk is small on a one year old phone and noticeably larger on a three year old one.
Does the water damage sticker void my warranty automatically?
It does not void the warranty for unrelated faults, but it removes liquid damage from cover, and in practice a tripped indicator means any fault that could plausibly be moisture related will be declined. Photograph the sticker before handing the phone over, so you know what it looked like.
My phone works fine two days later. Am I in the clear?
Mostly, if it was clean water. Keep an eye on three things for a fortnight: battery drain, speaker clarity and whether the cable needs wiggling to charge. Delayed failures happen when residue is slowly corroding a contact, and those three are the earliest signs.
More in Phones
Phones
SIM PIN and SIM Swap Protection and What Each One Stops
Your phone has a passcode, a fingerprint and probably face unlock.
Phones
Tempered Glass or Film Screen Protector and Which to Buy
You just paid for a new phone, and the shop assistant holds up two packets: a $35 tempered glass screen protector with "9H"...
Phones
Why Your Phone Is Not Charging and How to Fix It
You plug your phone in before bed, and in the morning it is sitting at 14 percent.